Once you have
downloaded your InTouch Machine Edition HMI project files to the target device,
you may run or stop the project at will.
There are three ways
to run or stop a project on a target device, depending on whether you are
currently connected to the device or managing the project remotely.
Ribbon
Assuming you are
currently connected to the target device and you have downloaded your project
files to it, the easiest way to run and stop the project is to use the
appropriate commands on the ribbon: on the Home tab of the ribbon, in the
Remote Management group, click Run or Stop.
Remote Management
If you are not
currently connected to the target device:
On the Home tab of the
ribbon, in the Remote Management group, click Connect. The Remote Management
window is displayed.
Click the Target tab
of the Remote Management window, check the connection settings, and then click
Connect.
Click the Project tab
of the Remote Management window, check the project settings, and then click Run
or Stop.
Remote Agent
If you cannot connect
to the target device:
Go to the target
device itself and make sure Remote Agent (CEServer.exe) is running on it.
In Remote Agent, click
Run or Stop.
Related
articles:
No comments:
Post a Comment